The Cooling System | Beginner’s Auto Maintenance & Repair | Jeff Crawford

The Cooling System: This chapter is about the cooling system for the engine, not the air conditioning used to cool passengers while driving. A cooling system is needed to dissipate excess heat created during the internal combustion process.

 

The Cooling System | Beginner’s Auto mainten-ance & Repair | Jeff Crawford

Cooling system mainten-ance is preventive mainten-ance done to avoid an overheating situation and to avoid electrolysis (the breakdown of metals that occurs inside the engine block). Cooling system mainten-ance mileage varies by make and model. ln some cases, mainten-ance is necessary before the mileage indicated in the owner’s manual. For example, if the manufacturer’s recommendation is a coolant flush at 150,000 miles, it could easily need to be flushed before that. If the coolant is low then there may be a leak. Leaks can occur at the water pump, heater core, hoses, radiator, and at multiple locations throughout the engine.

 

Auto Mechanic, Auto Mechanic Engineer, Auto Service Technician, Automobile Gurukul, Automotive Gurukul

 

The coolant is inspected at every oil change (about every 5,000 miles) and when it is found to be dirty then a cooling system flush is necessary. Typically the coolant gets dirty when non-distilled water is mixed with it. The impurities in the water cause corrosion (breakdown of the metals in the engine), which collect with coolant. This can clog the radiator and cooling passages. That is why coolant is mixed with distilled water where these impurities are absent.

 

When checking the coolant at home, be sure to never open the radiator while the engine is hot. (Remember Chapter 2: Checking Fluids).

 

How to flush the cooling system:

  • Refer to the owner’s manual for the locations of each part of the cooling system
  • Open the radiator drain to drain the cooling system and collect the drainage into a container (you can take this to your local auto parts store for recycling)
  • Remove the thermostat is typically on the engine side of the upper radiator hose, but in some cases, it’s on the lower hose.
  • Disconnect the lower radiator hose, and force coolant through the thermostat housing (upper hose and engine block) with a garden hose until the water runs clear
  • Connect the garden hose to the radiator, flush water through the radiator until the water runs
  • Completely drain the cooling system of all the
  • Reinstall the thermostat
  • Disconnect the reservoir and flush with the garden hose until the water runs completely drain the reservoir.
  • Connect the hoses and close the
  • Fill the cooling system with new coolant to the manufacturer’s specification and distilled Use a 50/50 mixture of coolant and distilled water or pre-mixed coolant.

 

Flushing the cooling system will not correct an overheating concern. lf your vehicle is overheating, (as indicated on the temperature gauge on the dash), it would need to be diagnosed and repaired.

 

The Cooling System | Beginner's Auto Maintenance & Repair | Jeff Crawford
Auto Mechanic, Auto Mechanic Engineer, Auto Service Technician, Automobile Gurukul, Automotive Gurukul

 

Any time you open the cooling system and put it back together you want to pressure test the cooling system to check for any leaks. You can use a pressure tester which can be rented from an auto parts store. lt will come with instructions. Generally, it attaches to the radiator where the radiator cap goes, and you pump it by hand until the pressure on the gauge matches the pressure that is written on top of the radiator cap. Typically on a modern vehicle, this pressure is between 13 – 16 psi. Let the vehicle sit with this pressure for 20 – 30 minutes. Then inspect the entire cooling system for any leaks and check the gauge for a change in pressure. lf there is less pressure than before then there is probably a leak.

The Cooling System | Beginner's Auto Maintenance & Repair | Jeff Crawford

The Cooling System | Beginner's Auto Maintenance & Repair | Jeff Crawford
Pressure testing the cooling system

Know more: 

 

The Cooling System | Beginner's Auto Maintenance & Repair | Jeff Crawford
Auto Mechanic, Auto Mechanic Engineer, Auto Service Technician, Automobile Gurukul, Automotive Gurukul

Leave a Comment